Self guide

CB Rowing Seat

This is the busiest time of the year as we try to squeeze in the last few sails and start up various winter building projects. Ive got 3 big projects planned for the winter (more on that in a later post), but before I can begin any of them, I need to finish Cabin Boys refit.

Since my last report, Ive given everything a good sanding, including sanding out the worst bits of chafe on the sheer strake and transom. The results are not perfect but as my old professor used to say, perfection is the enemy of good enough.

Ive also decided what to paint and what to varnish. Theres far too much bare oak in Cabin Boy at the moment. I once hoped I could keep the oak bright with oil -- which means some sort of linseed oil concoction. But after trying oil on various oak bits, Im thoroughly disenchanted with the results. Either the wood dries out, or it mildews.

So Im giving up on oil. Im going to paint most of the bare wood and will varnish the few bits that I leave clear. I had great results with varnish on my boomkin, and Im now convinced that varnish is a lot lower maintenance in the long run than oil.

But before I can paint I must finish building the interior out. First up is the fore an aft rowing seat.

Rowing Seat

The plans for Cabin Boy include plans for this style seat, which is by far the best (IMHO) for small dinghys. The idea is simple: if you are by yourself in the boat, you can sit in the middle of the boat and row with one set of oarlocks.

If you have a passenger, she sits in the sternsheets and you can slide your weight forward to balance the boat, moving the oars to a second pair of oarlocks if necessary.

Three people is probably too much for Cabin Boy, unless it is a very calm day and the rower very careful.

Im determined to complete Cabin Boys refit using scrap wood that has gradually accumulated in my shop. The seat is an offcut of white pine that was almost exactly the right size. Ive got another scrap that should be just right for the sternsheets.

The only tricky bit was shaping the forward end to fit CBs not-exactly-symetrical bow. This was just trial and error fitting with a block plane. I thought I had a later picture, but you get the idea. Eventually, I got a fairly good fit.

Fitting to the bow

I needed something to support the seat in the bow. I thought about buying some sort of bracket until I remembered that I was supposed to build everything out of scrap. I found a hunk of old white oak with the right grain and cut out this little support bracket.

Oak support bracket

As you can see, I even used recycled bronze screws. A little green patina doesnt make them any less screwy.

Bedded in

I thought about epoxying it to the stem, but Im a bit off epoxy at the moment, so I just bedded it in with Dolphinite. The two screws into the oak stem should be more than enough support.

I made the other support out of another scrap of white pine. A simple straight piece would have been good enough, but whats the point of having a bandsaw if you dont have fun with it?

Support strut

White pine doesnt hold screws very well, so I will fasten the strut in place using two oak cleats. All the screws will go through white pine and into an oak cleat, or the oak keelson.

Strut and cleats

The cleats will actually be forward of the strut where they will be more or less hidden from view.

I keep finding uses for a router. For example, for rounding over edges. Unfortunately, I dont have one, so I did the rounding with a block plain and sand paper. It came out good enough. I guess thats why I dont have a router, yet.

The long oak beam across the boat is just to support the seat when Im working on the strut. It will be removed when the installation is complete.

So thats the current status. More soon.



>>> Next Episode: Varnishing